I 3d printed couplers between the motors (y-axis) and the frame. Thanks for the help and i'm sorry for my bad english I measured all the wires but they seem to be correctly installed (also it works on the bench). I could move the axis by keyboard and when i run a program, i saw both motors do the exact same thing.Īfter that i reïnstalled both motors and BAM, the program crashes again. Than i unmounted both motors en tried them on the bench. As soon as i disconnect one motor from the Y-axis, the program works again. When i did that i noticed the software freezes all the time too. I googled and i saw i need to use the A-axis and use it as a slave to the Y-axis. When i did that the Mach3 software froze multiple times and starting a program wouldn't work. I have 2 motors for the Y-axis, so like in the previous board i connected both signals to the stepper drivers from the YP and YD connector. I previously had a Makerbase MKS DLC32 controller but that controller didn't work with my StepperOnline DM860T drivers so i bought a Mach3 board (the red one).
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |